Effect of ladle lining erosion on lining temperature and temperature drop of molten steel
ZHANG Qi-dong1, ZHONG Kai2, SHAO Jun-ning3
1. Steelmaking Department, Shougang Jingtang United Iron and Steel Co., Ltd., Tangshan 063200, Hebei, China; 2. Iron and Steel Technology Research Institute, Research Institute of Technology, Shougang Group Corporation, Beijing 100043, China; 3. Manufacturing Department, Shougang Qian′an Iron and Steel Co., Ltd., Qian′an 064400, Hebei, China
Abstract:In order to study the influence of ladle lining erosion on the liquid steel temperature drop, a heat transfer calculation model considering the lining erosion was established by using ANSYS finite element software and ParaMesh mesh migration technology. The effect of lining erosion on the lining and molten steel temperature were studied and analyzed. The results showed that the ladle lining erosion had a great influence on the ladle lining temperature. In the next two repair cycles, the temperature difference between the slag line and the wall of the ladle lining internal (the junction of working layer and permanent layer) caused by the ladle lining erosion was about 14-114 K. The ladle lining erosion led to the increase of the outer surface temperature of the cladding, and the increase of the outer heat dissipation of the cladding. At the same time, the lining was eroded and thinned, and the heat storage was reduced. Thus, the ladle lining erosion had a little influence on the liquid steel temperature drop, the maximum temperature drop was no more than 1 K. In the actual production, the influence of the ladle lining erosion on the liquid steel temperature drop can be properly ignored.
张启东, 钟凯, 邵俊宁. 钢包包衬侵蚀对内衬温度和钢水温降的影响[J]. 中国冶金, 2019, 29(12): 19-24.
ZHANG Qi-dong, ZHONG Kai, SHAO Jun-ning. Effect of ladle lining erosion on lining temperature and temperature drop of molten steel[J]. China Metallurgy, 2019, 29(12): 19-24.
Camdali ü,Tunc M.Steady state heat transfer of ladle furnace during steel production process[J].Journal of Iron and Steel Research,International,2006,13(3):18.
Samuelsson P,Sohlberg B.ODE-based modeling and calibration of temperatures in steelmaking ladles[J].IEEE Transactions on Control Systems Technology,2010,18(2):474.
[8]
Zimmer A,Lima A,Trommer R,et al.Heat transfer in steelmaking ladle[J].Journal of Iron and Steel Research,International,2008,15(3):11.
[9]
周建安,谢剑波,王宝,等.新型真空壳钢包研发[J].炼钢,2017,33(2):38.
[10]
LI G F,LIU J,JIANG G Z,et al.Numerical simulation of temperature field and thermal stress field in the new type of ladle with the nanometer adiabatic material[J].Advances in Mechanical Engineering,2015,7(4):1.