Application of surface inspection system in detection of linear defects on cold-rolled sheets
WANG Lin1, YU Yang1, NI You-jin2, FU Guang2, WANG Chang1, GAO Xiao-li1
1. Department of Thin Sheet, Research Institute of Technology of Shougang Group Co., Ltd., Beijing 100043, China; 2. Manufacturing Department, Beijing Shougang Co., Ltd., Qian′an 064404, Hebei, China
Abstract：Mold flux defect, bubble defect, inclusion defect and cold rolling scratches are the four typical linear defects on the surface of cold-rolled sheets. Due to the similarity of the macroscopic morphology for these four defects, it is difficult to accurately distinguish them by surface inspection system, which causes difficulty in the judgment, traceability and process improvement. The surface inspection results, physical morphologies and microscopic characteristics of each linear defect were compared through large numbers of sampling analysis, and the macroscopic and microscopic characteristics of every kind of linear defect were clarified. Based on this, the judgment rules and the defect library of the surface inspection system are optimized, thus the accuracy rate of defect judgment is improved from 80% to 90%.
王林, 于洋, 倪有金, 付光, 王畅, 高小丽. 表检系统在冷轧板表面线性缺陷检测中的应用[J]. 中国冶金, 2022, 32(9): 105-112.
WANG Lin, YU Yang, NI You-jin, FU Guang, WANG Chang, GAO Xiao-li. Application of surface inspection system in detection of linear defects on cold-rolled sheets[J]. China Metallurgy, 2022, 32(9): 105-112.
2022, Vol. 32 
